|
|
|
|
|
|
|
|
|
|
Back To Main Parts Index /
Back Technical Index /
Print Your FAX Form
HERE.
Technical Page 62:
Technical:
Page 53 /
Page 54 /
Page 55 /
Page 56 /
Page 57 /
Page 58 /
Page 59 /
The Bosch Magneto
The only care required by the magneto is the oiling of the bearings and
the occasional cleaning or adjusting of the contact points. Readjusting the
points is necessary only about once every 5000 or 6000 miles.
How to Oil the Magneto
A place for oiling will be found on both ends of the magneto, and four
or five drops of oil every 500 miles is sufficient for all needs.
The interrupter lever located inside the interrupter housing is intended
to operate without lubrication, and great care should be exercised to prevent the entrance of oil at this point, because if oil gets on the contact
points it will prevent a good contact and cause sparking and burning as
well as missing.
To Clean Contact Points
If the contact points in the interrupter housing become badly roughened,
pitted, or burned after extended service, they should be smoothed with
No. 00 sandpaper.
It is necessary to remove the chain guard to gain access to the contact
points. After removing the chain guard, take off the interrupter housing
cover "8" by sliding off the flat spring "4;" then remove the interrupter
housing by working it back and forth. The interrupter lever "2" is removed by sliding off the retaining spring "10" after removing the small
screw clamping the tension spring.
(continued on page 63)
Page 60 /
Page 61 /
Page 62 /
Page 63 /
Page 64 /
Page 65 /
Page 66 /
Page 67
Back To Main Parts Index /
Back Technical Index /
Print Your FAX Form
HERE.
Technical:
Page 53 /
Page 54 /
Page 55 /
Page 56 /
Page 57 /
Page 58 /
Page 59 /
Page 60 /
Page 61 /
Page 62 /
Page 63 /
Page 64 /
Page 65 /
Page 66 /
Page 67
|
![]() CLICK IMAGE TO ENLARGE |
ORDERS: UPS orders welcomed. |
|
|
![]() ![]() |
![]() |